YoDave CZ-455 Trigger Shim and Spring KitImproves the Trigger Pull of CZ-455, CZ-452 and BRNO Model 2, 4, and 5 Rifles This kit removes the creep and lightens the trigger pull weight by the use of shims and new springs. Kit includes 4 shims and 4 new...

Springs for the JARD CZ-457 Trigger Replacement springs to change pull weight on the JARD CZ-457 Trigger. These are the springs shown in the JARD CZ-457 Trigger instruction manual. You can swap in a stronger or a lighter spring to change the pull weight...

YoDave CZ-457 Trigger Spring Kit  With this kit, you can reduce the CZ-457 trigger pull to approximately half of what the factory spring will adjust down to. Used in conjunction with the sear adjustment screw located on the front of the trigger...

Remington 870 Trigger Tune Spring Kit This kit comprises of both a replacement hammer spring as well as five different trigger springs ranging in pull weight from 1.25lb to 5lb. The hammer spring is made from stainless steel, and the trigger springs are...

The Ultimate Trigger Kitfor the Ruger MKIV & MKIV 22/45 RedThis “Ultimate” Kit for Ruger® Mark IV™ & Mark IV 22/45™ is a matched set of upgrade parts - DO NOT use any other brand of sear and hammer with the TANDEMKROSS...

Colt SA Revolver RP Shooters Pak This Shooter's Pak includes a Wolff reduced power mainspring, a reduced power sear/bolt spring (flat-type), extra power base pin spiring and stainless steel hand ejector spring. These kits offer great improvement in the...

Colt SAA Revolver RP Shooters Pak This Shooter's Pak includes a Wolff reduced power mainspring, a reduced power sear/bolt spring (wire-type), extra power base pin spiring and stainless steel hand ejector spring. These kits offer great improvement in the...

Volquartsen Mk IV and Mk IV 22/45 Competition KitAlso Converts Mk IV and Mk IV 22/45 Pistols to Eliminate the Magazine Disconnect  Trying to figure out which parts are needed to take the Ruger MKIV and 22/45 to the next level? Look no...

Jard 3-Position Safety for Savage 10/110 RiflesThe JARD 3-Lever Triggers for Savage 10/110 require a 3 position safety. Check your rifle. If your Savage 10/110 series rifle has a 2-position safety, you will need to install one of these 3-position...

The Ruger 10/22® Competition Sear Kit lightens the trigger pull and smooths the trigger return. Hand stoned engagement surfaces. Includes a new sear, extra power sear spring, and two .004" trigger shims. This sear, when used with proper engagement of...