Choate Tactical Custom Savage Stock

Choate Tactical Custom Savage Stock
  This stock has a full length bedding block, a rail on the bottom of the forend to attach a bipod, and sling swivels on both sides. It also has a custom machined aluminum cheek piece of 6061 T6 with a .750 inch vertical height adjustment and a 3-way aluminum butt plate of 6061 T6. That can add up to 1.25 additional length of pull as well as horizontal adjustment of one inch up or down. A comfortable rubber butt pad finishes the butt plate nicely. Adjustment on the cheek piece is made with a rosette type knob. Adjustments to the 3-way butt plate are made with a 5/32 allen wrench. The length of pull can be adjusted from 13¼" out to 14½". This stock is meant to work with your factory screws.  

We have stocks to fit the Savage factory short or long actions, with or without accu-trigger. Choose the 4.27" screw spacing if you have a staggerfeed magazine. Choose the Centerfeed 4.41" screw spacing if you have the newer centerfeed magazine. Choose Detachable 4.41" if you have a Rifle with a Detachable Magazine. The "Long Action" version fits 5.062" screw spacing.
  Fits-All Barrel Channel - Since "free floating" of the barrel is preferred on all bolt actions, Choate has set this stock up to fit any barrel including the widest diameter bull barrels. Skinny barrels will have a wide gap between the barrel and the forend but they will shoot accurately from this stock.
Fitting Information - Long Actions have a screw hole spacing of 5.062". Center Feed is when you remove the action from the stock and the magazine stays in the stock. Stagger Feed is when you remove the action from the stock and the magazine box stays attached to the receiver.
  Detachable Magazine Fit - A detachable magazine is when the magazine can be detached from the stock. This Choate stock will fit the original Savage detachable magazine bottom metal with the latch in the front. It will NOT fit the detachable magazine rifles where the magazine latch is part of the magazine! Also, it will NOT fit the Savage detachable magazine rifles with the aftermarket Accurate-Mag bottom metal that uses the Accurate-Mag magazines. This stock WILL fit detachable magazine rifles with the bolt release located on the bottom of the rifle OR on the top side. Does NOT fit Axis/Edge.
  Hinged Floor-Plate Fit - Use Detachable Magazine Stock and fitting requirements, screw spacing, etc..
- There will be an 3/16 gap under the safety on all the Savage Varmint, Tactical and Sniper stocks. The action should only touch on the V of the bedding block and back of the recoil lug. The gap at the back is normal for Savage actions when installed in our stocks.

Anything that is not labeled "Detachable Magazine" is a blind magazine.